SKR 1.4 - Basic Switch Endstop

  • 🎬 Video
  • ℹ️ Description
preview_player
UCQgi4B8mn_HYUkIImt30B9g

Explains basic switch endstop sensor and how to enable and load correctly in Marlin Firmware on SKR 1.4 motherboard.

One Time Tips, You Can PayPal Me:
Discord:
Patreon:

Hardware:
Hardware:
1 - BigTreeTech SKR 1.4
1 - USB Cable
1 - Switch Endstop

Amazon Affiliate Links:

Documentation and Firmware

Software:
Marlin Firmware 2.0.x

Pronterface:

💬 Comments
Author

Can't wait for the BLTouch setup, I'm having some trouble with this.

Author — DutchDudeTv

Author

am I correct that the btt endstops have included resistors and condensators, ? so more meant for replacement of for newly builds ? technically you could use build in pullup/down ? (not sure if SKR1.4 has that option)

Author — patrick maartense

Author

So I have an Ender 3 and my end stops have a 2 wired plug.. yet the skr 1.4 have 3 pins.. should I use the +5v and ground then ?

Author — Michael van Dijk

Author

Hello, I have a creality cr 10 with only two connectors, but I suppose that the 5V only serves to power the led. My concern is that after following the tutorial, the machine completely ignores the switch. Do you have a solution, thanks in advance. On the other hand, ponterface clearly sees the changes of state.

Author — ERAGONTH

Author

HELP!!! #error "Z2_USE_ENDSTOP has been assigned to a nonexistent endstop!" ON SKR1.4 TURBO

Author — mario marinez